Levitating height
up to 71mm
An unloaded disk levitates a 71mm. With a full 4kg load, the levitation height is at 28 mm.
For maximum visual effect, a load of 2 kg max is advised.
See table below for load vs levitation height.
| LOAD | LEVITATION HEIGHT |
| Load = 0 kg | H_levitation = 71 mm |
| Load = 1 kg | H_levitation = 52 mm |
| Load = 2 kg | H_levitation = 43 mm |
| Load = 3 kg | H_levitation = 35 mm |
| Load = 4 kg | H_levitation = 28 mm |
Connection:
Two-pin EU standard electrical plug (US powerplug optional)
Adaptor:
Voltage input (AC): 100-240V Voltage output: 19V Current: 6A peak
Power consumption:
(rest position): ≈10W
Both carrier and base contain powerful magnets, therefore Crealev advises to keep magnetic sensitive devices such as credit cards at a minimum distance of 50 mm (2”) from the device.
Maximum load size:
Maximum load location on top of carrier ring:
| Load = 0 kg | H_load = – | H_levitation = 71 mm |
| Load = 1 kg | H_load = 190 mm | H_levitation = 52 mm |
| Load = 2 kg | H_load = 130 mm | H_levitation = 43 mm |
| Load = 3 kg | H_load = 105 mm | H_levitation = 35 mm |
| Load = 4 kg | H_load = 90 mm | H_levitation = 28 mm |
You can hide our technology to make your product levitate even more magically. There are just some things to take into account in order to prevent damage to your levitation module.
The Void71 and the Octo88 have a standard built in fan; two air intakes with fans, and two air outputs. So if you hide the module inside an enclosure, it is very important separate the cool air coming in, and the warm air going out of the enclosure and to equip the enclosure with an extra fan to suck in cool air.
An example and instructions can be found in the manual “hiding_module” on this page.
The important things
- Try not to stretch the limits of the module in terms of a too heavy object, or too high. (this will create heat.)
- Make sure there is active ventilation.
- Make sure the airflow is bottom to top.
- Make sure the hot air and cool air don’t mix.
Reviews
There are no reviews yet.